Keep the 2 fender bolts they will be re-used when installing new airboxes. Loosen clamp at end of intake tube holding tube onto the turbo. Loosen the clamp on the hose near the top of the tube towards the air box and slide off the hose.
With the clamp loose and the hose removed, gently loosen the intake tube to allow better access to the re-circulation hose. Use pliers to open the clamp to allow for the hose to be taken off the intake tube. Then finish removing the intake tube. Removal Passenger Side Intake Tube. Loosen the clamp at the end of the tube that is attached to the turbo. With pliers squeeze open clamp to allow to pull off the re-circulation tube. Then remove the intake tube. Installing Driver Side Intake Tube. Using the intake tube with 2 fittings and inlet.
Install coupler onto intake tube then onto the turbo. Tighten but leave loose until the air box is secured into place. Install re-circulation hose and use pliers to place clamp into position. The clamp at the blow-off valve may need to be loosened and turned to prevent the factory hose from kinking.
Air Box Installation. Remove the 2 rubber grommets from the factory air box. Push metal center out then grommet should be flexible enough to remove. This duct can also be used with the stock intake box or aftermarket intake kits to direct cooler air into the engine compartment. The installation of this duct requires the removal of the nose from the RX-8 and can easily be undertaken by people in about an hour.
Fully detailed instructions, with numerous photos included, will guide you through the installation process. Although this process might sound rather challenging, the process is relatively straightforward and can be undertaken using only simple hand-tools.
Designed to offer performance improvements without sacrificing drivability, the Racing Beat intake system is the final result of hundreds of hours of Racing Beat designed the RX-8 Radiator and Oil Cooler Screens in an effort to provide additional protection to the "exposed" air conditioner condenser radiator and oil coolers. Racing Beat designed the RX-8 Oil Cooler Screens in an effort to provide additional protection to the "exposed" oil coolers.
Although Mazda positioned the oil coolers in a strategic position to allow maximum airflow, this positioning also allows
0コメント